It looks like you're new here. If you want to get involved, click one of these buttons!
Voltigeur MkII 3D
I have found a few Issues with this model. 1) The Spinner supplied the holes in the Backplate are bigger than the Screws Supplied, So I tapped it out to that 3mm bolts and the first time I screwed the bolts in without Tightening them up the Plastic just came away?
2) On trying to fit the Spats, found that the Wheels didn't fit in the Spats I could of Modify but shouldn't have to, it's an almost ready to fly Model.
3) Not enough Nuts supplied to install the Wheels.
4) Rudder & Elevator Servo Mounting Plates both not Glued properly