yep 100a in twin edf set up setting help please

pmdevlinpmdevlin Club Members Posts: 25 ✭✭

Hi,

I'm flying a twin 70mm edf me262, and have just fitted a pair of these esc. Using card, I have timing to auto, brake off, cut off off (I always use low volt alarms) freq is at 12khz (no idea what this is!) auto power up, plane set to medium. On the bench, with varied throttle, they got warm in two mins, and they where out of the model in cool air. Are there any changes to settings that will help? Both signal wires disconnected as I use a cc10a bec, 6 cells, Dr Mad Thrust 2200kv 1600w 70mm EDF Inrunner 6S version (29mm) with 10 blade change sun rotors
thanks for any help

Comments

  • WTWUKWTWUK CornwallClub Members Posts: 13,613 ✭✭✭

    Set frequency to 8KHz. 12 is too high and will cause warming. Set startup to high so there is no delay.

  • pmdevlinpmdevlin Club Members Posts: 25 ✭✭

    many thanks!

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file