Realtor 300w 20a ac-dc DC OUTPUT SETTINGS

ColourMAGICColourMAGIC Club Members Posts: 2

Purchased the above charger from HK
?? What are the settings for the charger to provide 15v 23a DC output when connected to AC
cM

Comments

  • WTWUKWTWUK CornwallClub Members Posts: 13,608 ✭✭✭

    There are no options to set that as such.

    What exactly are you trying to do with it?

  • Markus HoppmannMarkus Hoppmann Club Members Posts: 1
    edited December 2018

    Hello Everybody,
    I bought the same charger, and I don´t get the right settings too. I try to charge the following batterie: ZIPPY 4000mAh 2S1P 30C Hardcase Pack. The settings I choose is: Lipo , Charge, 20.0A and 7.4V (2S). If I press start for 3 seconds I get a warning signal and the message disconnect.

    What could be the problem?

    Thank you

    Kind regards

    Markus

  • WTWUKWTWUK CornwallClub Members Posts: 13,608 ✭✭✭

    Try charge rate at 4.0Amps.

  • ColourMAGICColourMAGIC Club Members Posts: 2

    Colourmagic
    I have developed a 40000mah 15v power pack and distribution system for a video production camera system. I want to run the power pack from the batteries or if close to an AC source then switch over to run the power pack outputting 15v direct from the charger.
    All the sales specs in HK (even today) and other sites state that ...
    When connected to AC the charger can provide 15v 23A as a dc supply as output to another power supply.
    I just don't how to set it up.

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file