Turnigy 9x receiver and Naze 32

aziolkaziolk Club Members Posts: 1
I am trying to assemble my first RC build. I purchased a Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware). I am trying to use the receiver that came with the controller and a Naze32 board.

I can bind the receiver to the transmitter and successfully test it on individual ESCs. However, once I connect the receiver to the Naze32 via the pre-soldered 2x5 pin input, I no longer receive a response to the controller.

I have checked to make sure the plug orientations are correct and that the Rx/Tx are still bound. I flashed the latest firmware to the Naze32. I am currently using CleanFlight Configurator.

Has anyone encountered this problem or have any troubleshooting advice? Thanks.

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file