Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Help With TGY-I6

TexasDroneTexasDrone Club Members Posts: 8
Hello, I Have the Naze 32 F/C and a TGY-I6 Transmitter and Receiver. However, I am running into a problem when I try and hook up my flight board to my receiver. The problem is that my pitch and yaw are, for some reason hooked up to my Aux 1 and Aux 2 controls on my remote, but not vise versa. I am connecting it in the typical ch 1 -aileron,ch 2 -elevator,ch 3 -throttle & ch 4 rudder setup using this map Here of the F/C. Can anyone provide any insight on what is going wrong or what I should do?

Comments

  • WTWUKWTWUK CornwallClub Members Posts: 13,511 ✭✭✭
    Pic of your actual wiring please. And how are you connecting? PPM single wire or PWM wire from each receiver port?



    Your 'map' pic makes no sense as it is for Spektrum TAER format.
  • TexasDroneTexasDrone Club Members Posts: 8
    Then what setup should I use for a TGY-I6



    Here are the pictures: Here
  • TexasDroneTexasDrone Club Members Posts: 8
    There
  • jstremmlerjstremmler Germany&U.S.A.Club Members Posts: 436
    Your problem are the connections between RX and FC.



    You did not connect the cable of:

    - pin 1 of your FC to channel 1 of your RX

    - pin 2 of your FC to channel 2 of your RX

    - pin 3 of your FC to channel 3 of your RX,....





    Do it and it will work!jstremmler2016-06-14 16:48:29
  • dart16dart16 Club Members Posts: 77
    and

    pin 4 of your F/C to channel 4 of your RX

    pin 5 of your F/C to channel 5 of your RX

    pin 6 of your F/C to channel 6 of your RX

    image



    You are numbering the outputs of the RX from the right end aren't you?

    imagedart162016-06-14 19:46:06

Leave a Comment

BoldItalicStrikethroughOrdered listUnordered list
Emoji
Image
Align leftAlign centerAlign rightToggle HTML viewToggle full pageToggle lights
Drop image/file